MicraPRO
Part Of The Furniture
On car adjustable... looks cool... brand new not rusty... get to put NodSpeed stickers on my car haha.
I got one because it's the right way to do it.
what did you do to your micra today ?
- Thread starter frank
- Start date
I got one because it's the right way to do it.
Fujiwara-Ben
Site Supporter
For a 40mm drop i wouldn't worry too much. I've lowered mine 40mm and you can hardly notice that the back wheels have moved.
It's not really noticeable and i don't find it effects the way it drives.
It's not really noticeable and i don't find it effects the way it drives.
Clodo
Club Member
I havnt had one since September x
MicraPRO
Part Of The Furniture
But you DO have one waiting to go on...
h701micra
Deactivated Account
Because 1 degree of difference in the track can make a big difference to handling.
You wont notice if you dont know what you're looking but for those that you will physically see and feel a difference to cornering capability
Either way the panhard rod axle is a flawed design. As are the load compensator valve things K11 have
Just finished fitting a small 2M Ham Radio into the car. I found that having the car stripped out gives a nice little gap just above the black box for the airbag (just below the ashtray). I hope it's well RF shielded!!
im sure you 2 are secret coding on here
One 2M Radio fitted into a small bit of the stripped out interior
The mrs micra went in for mot today, straight through , no advisories.
Had a weld on the front cross member before the mot, noticed it the other day, only about an inch. Did notice though that it was caused by the splash shield holding water against the beam, design fault maybe ? Mine doesn't have one, came off in the smack she had before I bought her, cross member last time I looked....perfect. A lesson to be learnt maybe???? make sure yours is not doing the same.
Had a weld on the front cross member before the mot, noticed it the other day, only about an inch. Did notice though that it was caused by the splash shield holding water against the beam, design fault maybe ? Mine doesn't have one, came off in the smack she had before I bought her, cross member last time I looked....perfect. A lesson to be learnt maybe???? make sure yours is not doing the same.
Been driving for a week or so now with no engine problems (cutting out at 4k revs) I have noticed that if I take her up to 4k slowly...no problems. If I slam her to 4k .....bang, the problems back? stop for 10 seconds....problem gone.
H701 did mention this TPS sensor, is this sounding likely considering the symptoms???? Also, where is it??
H701 did mention this TPS sensor, is this sounding likely considering the symptoms???? Also, where is it??
cant see motor info here,only the switches on panel .maybe you can ----slx type.
http://nissan4u.com/parts/micra/el_k11e/1996_6/type_18/body_side_and_rear/front_door/
super s type
http://nissan4u.com/parts/micra/el_k11e/1996_9/type_22/body_side_and_rear/front_door/
Magpie42
Actual Magpie.
One 2M Radio fitted into a small bit of the stripped out interior
Did you get a massive aerial to go with it?
My dad used to have one of those in his Mazda E2000 van....although, I never knew why....
Too my eyes it looks like what your describing could be a fuelling issue?
Running ok but under hard throttle under fuelling ect?
My 2pence
started to remove my brakes today as they was worn and rounded off a bolt and now need a new caliper
Apologies for being so pic heavy
Not today but over the last week.
Following a colision with a hedge mostly due to wiltshires ####ty roads, car was straightened out within 18hrs thanks to the old man n my brothers. Have since proceeded with some minor alterations and much photo whoring. I think she looks better now in some ways. Just gotta keep an eye out for a decent replacement wing n then gunna spray both bumpers black.
Not today but over the last week.
Following a colision with a hedge mostly due to wiltshires ####ty roads, car was straightened out within 18hrs thanks to the old man n my brothers. Have since proceeded with some minor alterations and much photo whoring. I think she looks better now in some ways. Just gotta keep an eye out for a decent replacement wing n then gunna spray both bumpers black.
Attachments
h701micra
Deactivated Account
Did I?
I can't rememberIts an age thing LOLDid I?
Just a small 1/4 wave atm (about 18" long). I will be fitting a Trunk Mount antenna to the bonnet tomorrow, so the 7/8 wave will be used
saw you on saturday! me and my mate were in his glanza in front of at bumpers farm and heading towards wick or whatever that place is called! hope the screamer pipe sounded good
saw you on saturday! me and my mate were in his glanza in front of at bumpers farm and heading towards wick or whatever that place is called! hope the screamer pipe sounded good
Ha ha I saw ya laugh as ya pulled away from me
glanza is tidy tho. Moves quick mines 1l auto tho 
Ha ha I saw ya laugh as ya pulled away from me
hahah yeah i was smiling ear to ear thinking someone else in wiltshire has another modified micra! well chuffed to see it! and no wonder we left you pretty soon then! bet 1L auto is slow as ****!
Max out at 90, goes well in sport but drinks fuel, low range is good fun
iv seen a few others round here, white 4 door pre face and a blue 2 door facelift both in corshamMax out at 90, goes well in sport but drinks fuel, low range is good fun
yeah the blue facelift is seb, havent seen it in person yet. 90?! ive got mine to 110!
only thing that would make it any faster is the back box thats been changed but it wouldnt be huge haha
h701micra
Deactivated Account
Non really without some work
What engine is in the primera?
h701micra
Deactivated Account
GA's, QG's and SR's were all present somewhere along the primera timline
I'd be interested to know this too.
