Hi All hope you can help or can point me in the right direction! I have a 160SR that ( don't laugh ) I use for driving lessons, I am a driving instructor.
I used a sport + 1.2 before and it was a great little car. The problem is that the throttle peddle is a little sensitive for when the pupils set the gas to find the biting point. I took the peddle off in the hope that I could perhaps just add a resistor to the wiring that would allow me to change the resistance at the touch of a switch. I hoped that full throttle on the pedal would only register half throttle as far as the ECU is concerned. This also would give a little less sensitivity when first pressing the pedal. At the moment you only have to press it about 2 or 3mm and it revs right up! Basically I want to calm it down a bit, then on my way home I can switch it back and hoon home lol. I became stuck when I discovered more wires than I expected! any bright sparks out there able to help me? thanks.
I used a sport + 1.2 before and it was a great little car. The problem is that the throttle peddle is a little sensitive for when the pupils set the gas to find the biting point. I took the peddle off in the hope that I could perhaps just add a resistor to the wiring that would allow me to change the resistance at the touch of a switch. I hoped that full throttle on the pedal would only register half throttle as far as the ECU is concerned. This also would give a little less sensitivity when first pressing the pedal. At the moment you only have to press it about 2 or 3mm and it revs right up! Basically I want to calm it down a bit, then on my way home I can switch it back and hoon home lol. I became stuck when I discovered more wires than I expected! any bright sparks out there able to help me? thanks.