Antony
Ex. Club Member
erm, complicated one guys..
when i was at squarepants a few months ago i was fitting the janspeed manifold and had to remove the front anti roll bar mounts.... uppon removal of the manifold (for mot) and replacing the mounts i may have snapped the threaded nut from inside the chassis (its snapped off the chassis inside and is stuck on the end of the bolt)
is there any way of getting to the top of this hole and sticking a propper nut on there as i was doing a bit of spirited driving earlier after a mitsubishi colt Cz-T and whilst catching up to it in the twisties i heard a loud clunk from the anti roll bar (banging the under side of the car) and its getting worse..
or is my chassis knakered??(Y)
when i was at squarepants a few months ago i was fitting the janspeed manifold and had to remove the front anti roll bar mounts.... uppon removal of the manifold (for mot) and replacing the mounts i may have snapped the threaded nut from inside the chassis (its snapped off the chassis inside and is stuck on the end of the bolt)
is there any way of getting to the top of this hole and sticking a propper nut on there as i was doing a bit of spirited driving earlier after a mitsubishi colt Cz-T and whilst catching up to it in the twisties i heard a loud clunk from the anti roll bar (banging the under side of the car) and its getting worse..
or is my chassis knakered??(Y)