Hi All
Last few days been having some issues with my K11.
In Sept 2016. I did the old re-solder of the throttle housing board & up until now my K11 been running perfectly. Back in 2016 the foul running was happening at all speeds. Losing power not accelerating etc
However, this time it’s like at idle. Especially at junctions. Idling lumpy then cutting out and then very difficult to start. Hot or cold. It might be something to do with the really cold weather? Though at normal revs all working fine.
I know when I re-soldered the board it was more of temp fix as I didn’t know what I was really doing. However, I am wondering if I need to do it again more properly. Or if this could be something different?
Last few days been having some issues with my K11.
In Sept 2016. I did the old re-solder of the throttle housing board & up until now my K11 been running perfectly. Back in 2016 the foul running was happening at all speeds. Losing power not accelerating etc
However, this time it’s like at idle. Especially at junctions. Idling lumpy then cutting out and then very difficult to start. Hot or cold. It might be something to do with the really cold weather? Though at normal revs all working fine.
I know when I re-soldered the board it was more of temp fix as I didn’t know what I was really doing. However, I am wondering if I need to do it again more properly. Or if this could be something different?