would corsa mk1 alloys fit micra k11

[pritz]

just wanted to know whether corsa mk1 alloys would fit a nissan micra k11 the bore size on corsa is 56.1

 

[superls]

the pcd is the smae but i dont know about the centre bore, but it wont ba a mile off so is not the end of the world if its slightly bigger/smaller

 

[Shaun]

According to fitment guides the corsa alloys would be Corsa 4x100 38 to 45 56.6

good luck (Y)

 

[superls]

i take it 56.6 is the centre bore? if so then no they wont direct fit, as the centre bore of the micra id 59.1 i think, so will need to be machined out ideally.

 

[Shaun]

which could cost a fair amount to get perfect

 

[getawaycar]

Or you could fit spacers to clear the centre.

The problem with most Corsa alloys is the positive offset. Especially earlier Corsas.

You may find the wheels fit too far under the arches and it could upset the handling.

If you have still to buy the wheels couldn't you just trial fit them?

 

[adamsricky]

if the alloys have spiggots in which they should, just remove them with a hammer and punch and use the nuts to centre the wheels i have done this and have wobbling upto 100mph

 

[adamsricky]

forgot to mention my alloys are off a corsa and are now on my k11 fit fine if above is carried out

 

[pritz]

hello people thanks for all the help i think im just going to let these wheels go id prefer some that go on without any hassle but thanks again.

 

[adamsricky]

if the alloys have spiggots in which they should, just remove them with a hammer and punch and use the nuts to centre the wheels i have done this and have wobbling upto 100mph

i ment i have no wobbling