pre-facelift 1.0 ones are smaller dont forget leonyeah clicking sort of noise its did it before i lowered it to, :/best buy new one haha
if you change the passenger side one with the correct one too, then you,ll be fine and yes some c/v,s have a 30mm nut and some 32mm (same thread tho )are they? lol i've already changed drivers side that was completely shot when i had the car haha, that ones got a slightly bigget center nut haha
Hi guys, I got another problem. It starts click noises when I turn. Both sides got cv spilts and dry greases so it's been for almost two months now. I know I should change both new cv gaiters before (which will save the money and avoid getting it damage later on.)
Is my driveshafts and cv joints are damage? How can I check if they are damage or not? I was thinking to get new cv gaiters on both sides.
Any advice please
Thanks
Jk
what sort of noise jk ? constant clicking ?
My make a funny noise on full lock but only in reverse....
When going forward they make no noise on full lock... I trust mine to make long journeys. Its very rare I'm on full lock on a motorway
I'd firstly suggest check your cv boots.
Regardless if they're intact or not. Jist unclip them and check how much cv grease you have in each.
Top them up if necessary. They don't need much at all. I only use 4/5 tablespoons in total
Clip them back up. Take it for a run and let the grease get around and try again
If they're split definitely get them changed and greased asap
were your eyes open when you were hitting it jk ! ? i had 1 that did,nt want to let go a while back, you may as well fit another shaft mate
were your eyes open when you were hitting it jk ! ? i had 1 that did,nt want to let go a while back, you may as well fit another shaft mate
I use 10w40 engine oil. Far cheaperIn first round, I was. I close my eyes before I hit on these right position. I try hard, harder and hardest so finally, it came off now. I managed to break this cv joint.
I lost all my gearbox oil. Do I need to get 75/90 of 3 litre?
Sent from my iPhone using Tapatalk - now Free
ahhh bad luck mate
through cable or through cable gear box plug
Hi guys its been for long time. My Mot was expired last Friday. These noises are still drive me so mad! I think these driveshafts are wreck so i need to get two new whole driveshafts. Does anyone know where can i get two please? I checked on ebay before so it looks like replica/fake to me so please tell me where can i get driveshafts. i will make new thread now. thanks
Right now, its still knocking noise. i think it from passenger side. i will have a quick test tonight in asda car park. I think these inner cv joints are wreck. i don't want to buy separate parts so i just want to get two complete drive shafts with cv joints too. I checked with euro car parts so they dont sell micra k11 drive shafts anymore. I will need to have double check with them.
I just spoken to well known euro car parts staff in my local. he said that they re-stock again so its £68 each. (cv joints is £40 each ) I know its an expensive so if i get two new drive shafts then i will save my time and less work too. scrappers will ask for two for £100. i hate scrappers man. i think i will get from euro car parts.
ball joint hub and track rod joint? huh? thanks i will have a look tonight.
shall i book new mot now? i need to drive this car tonight somewhere and dont want pull up by police.
thanks
yea thats right.
single cv joint
http://www.eurocarparts.com/ecp/c/N...721003fdd61460470c68d0c7a7c4e11b1a0df8&000095
complete drive shaft
http://www.eurocarparts.com/ecp/c/N...39b85a207d87e61535708d1aa76312a7a44b8f&000113
http://www.eurocarparts.com/ecp/c/N...f29d34ad75909ee53a5e067d0cf92e0a850627&000113