Search results

cam timing looks ok eh, assuming it was the 2nd notch on the crank pulley

there are a few vw/audi ones about that rob, ev1 ev6 or whatever ?

here,s the dyno printout, went mega rich then held at 13ish afr you can see the erratic closed looping on the other 2 runs https://www.micra.org.uk/threads/fixing-afr.70253/

i had a switch on the coolant temp sensor, and did some back to back dyno runs the 1.3 exh cam probably gives a gain, just not as much as the inlet imo http://www.micra.com.au/community/message.php?messageid=81838

yes plenty of threads on here with lumpy idle and low power after a cam change, try a search on lobes in my username and the forced closed looping at lower speeds is there to protect the cat on long steep hills imo

the cams should have made a noticeable difference, are your lobes set like this ? and i deleted the road speed signal to the ecu on mine , to cure the lean burn on acceleration https://www.micra.org.uk/threads/k11-1-0l-with-1-3-cams-wont-start.63651/#post-712169

there are about 5 different types of g/box, is yours a cable speedo drive ?

are,nt the coilpack starters fitted on the other side paul ? under the inlet mani

the post 2000 ones do maarten

the shafts wont cause a non start, but this happens to the manual boxes, maybe the autoboxes too ? https://www.micra.org.uk/threads/gearbox-woes.66904/

the bevel gears slide out on the manual box,s

yes very different, there will be some pics on here somewhere

its just the coilpack ones that are different

looks like fine cracks and rust pitting eh, maybe the piston was high up and flooded with water at some time ? all you can do is try it and test the compression i guess

:) https://www.micra.org.uk/threads/rear-wheel-hub-nut.61980/

its been covered a few times on here

there is a procedure to faultcode it somewhere on here edit https://www.micra.org.uk/threads/ncvt-problem.48828/

i dont know mate

the fill plug is on the front like the 1.3 ones, but a hex key on coilpack ones instead of square its the preface 1.0 that has no fill plug

yes live readings of the maf etc https://www.micra.org.uk/threads/tost-the-official-spam-thread.53370/page-63#post-651217