Hello again chaps,
After getting the front brake problem on my wifes 1.3 micra auto sorted..new calipers both sides....I now have another problem...when either drive or reverse is selected the car wont creep at all..it stays stock still. Ive checked the rear brakes for binding and they are totally free..the front have just been renewed and are likewise.
I noticed that there was a fair amount of slack on the throttle cable so I adjusted it to take it up...but not to much as to take the cam off the Idle stop screw...this made no difference.
I then adjusted the idle control valve (as per instruction)...this also made no difference.
Now bear in mind I do not have a Rev counter/Tacho fitted..nor a hand held one so everything was done by ear.
Very slight pressure on the pedal does make the car "Creep" but I feel that the revs are too high, Im saying to high in comparison to our other Automatics that weve had/have,
Any advice on this would be most welcome before I take it off to my local Garage,
Regards,
Steve.
After getting the front brake problem on my wifes 1.3 micra auto sorted..new calipers both sides....I now have another problem...when either drive or reverse is selected the car wont creep at all..it stays stock still. Ive checked the rear brakes for binding and they are totally free..the front have just been renewed and are likewise.
I noticed that there was a fair amount of slack on the throttle cable so I adjusted it to take it up...but not to much as to take the cam off the Idle stop screw...this made no difference.
I then adjusted the idle control valve (as per instruction)...this also made no difference.
Now bear in mind I do not have a Rev counter/Tacho fitted..nor a hand held one so everything was done by ear.
Very slight pressure on the pedal does make the car "Creep" but I feel that the revs are too high, Im saying to high in comparison to our other Automatics that weve had/have,
Any advice on this would be most welcome before I take it off to my local Garage,
Regards,
Steve.