Tuukka you wont find any plugs for them in the standard k10. going to have to connect them individually. connect the yellow one to the switched 12V that would go to the coil in the k10. you would have to splice this connection as well to send power to the solenoid over by the ufo and to the supercharger light. the other wire from the solenoid goes to the yellow with red stripe, that is the switching ground for the solenoid. the other wire from the supercharger light goes to a black wire (i think), that is the switching ground for the supercharger relay.
there is a pink with white stripe which is the idle up for lights. the blue green one is the idle up for ac i think, splice that in to the wire to compressor. there is a white with blue stripe which i think goes to the speed sensor if you have one in your speedo. i don't plan on using the rest. one is for temp signal to instrument panel and the k10 has that run already, the two orange and black i will not be using, and i condemned my map sensor and electrical gauge for a mechanical one.
Ed, welcome to the thread. Was wondering if you know which wire from the back of the speedo is the speed sensor output. i see 2 of them.
