GA16DE Airbox inlet size

[Enuo]

What is the inlet piping size for the GA16 airbox? I was thinking that one of these:
http://www.carbonmods.co.uk/Products/Carbon-Fibre-NACA-Duct-50mm__CMNACA5001.aspx
Might make a good cold air feed to the airbox, especially if it's holding a K&N. A bit easier than the ram air intake I was considering before too...

 

[skymera]

I think the inner diameter is 63mm. I had a 70mm pipe which with some convincing fit snug over the top.

I've no measuring device so cannot check for sure

Sent from my GT-I9100 using Forum Runner

 

[Enuo]

awesome, I'll just go next size up on the naca duct. Sweet.

 

[Skinner_87]

awesome, I'll just go next size up on the naca duct. Sweet.

If your not set on a carbon duct mate the plastic versions are much cheaper

 

[Enuo]

If your not set on a carbon duct mate the plastic versions are much cheaper

Awesome, that sounds even better. Do you have a link?

 

[Skinner_87]

Awesome, that sounds even better. Do you have a link?

There you go mate loads more on Ebay

http://www.ebay.co.uk/itm/Revotec-S...arts_Vehicles_CarParts_SM&hash=item4852eaf67f

http://www.ebay.co.uk/itm/Butler-Bu...arts_Vehicles_CarParts_SM&hash=item1c3190044e

 

[Enuo]

Ta, this is definately going to happen.