ecu wire help asap aus k11

[CMF_cookiesmicra]

Need to find
12volt pos
neg
rpm
ign(spark)

photos or pin numbers please any one

i have tryed google an the forum. Need help asap.

 

[CMF_frank2]

on this pic,
a 12v feed from the relay is pinout 38 and/or 47 (green and white ?)
neg is 39 and/or 48 (black)
the tacho is pinout 2, (blue and black ?)

 

[CMF_cookiesmicra]

Awesome thanks frank just one more if you can the Ignition signal wire ?? Thank.you so much

also what is pins. 22,21,110 and 109 cheers

 

[CMF_frank2]

22 cam position sensor (cas) ?
21 sensor earth ?
110 injector #2
the maf. cas, tps and o2 sensor signal wires were all white on mine (shielded too) and earthing the tacho wire will cut the engine btw

 

[CMF_cookiesmicra]

Cheers frank. Silly question iv looked at the pages to install a bee r limiter and i have followed the instructions(on this fourm) yet it still wont perform as it should. The photo i was using iv added below. Yet the one you added above says a complete diff story. Im so confused. Its a 1995 lx micra aus delivered with 1.3 i need rpm(yellow wire) Ignition signal(green wire) pos(red wire) neg(black) any idea or help mate

 

[CMF_cookiesmicra]

This link you added to another bee r limiter. I used the blue photo in it yet the pin numbers are un like the ones you posted. http://www.micra.org.uk/threads/bee-r-rev-limiter-launch-control.55290/#post-581271 thanks mate

 

[CMF_frank2]

I would go by the diag that scott posted in that link mate 47 is the relay feed (12v) 48 is an earth 2 is the tacho and 1 is the transistor for the dizzy

 

[CMF_frank2]

I can email the non_nats huge diag later if you want

 

[CMF_cookiesmicra]

Yes please frank my email is [email protected] ok ill try it again tomorow. It just wasnt reacting how the one in the video in the link was so thought as may have differant wiring maybe? Thank you for your help

 

[CMF_frank2]

done

 

[CMF_cookiesmicra]

Thabk you frank. Ill let you know how i go when i attempt it again