Hi Agent_Sm1th
Thank you for the procedure - I was using this and found the following :
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds. - I did this.
2. Then turn ignition switch to OFF position. Leave key in ignition switch. - I did this.
3. After 2 seconds, the system will enter programming mode and will flash the warning
lights twice. - The warning lights (neither hazards or alarm led) did not flash twice - system did not go into programming mode.
So I tried altering the timings of my ignition 'switchings' and, after a lot of faffing, found that if I did it as fast as I could - completed the 6 times on/off - in about 5 seconds, then the system will enter programming mode.
OK - next step - getting the remote fob to 'talk' to the system, - again, I needed to be very quick with the timing of the fob button pressing, so
4. Press and HOLD the unlock button on the Plip. - OK
5. While pressing the unlock button, press the lock button 3 times in succession quickly. Has to be done is less than 2 seconds otherwise is not recognised.
6. Release the unlock button. OK
7. The warning lights will flash once to indicate successful programming. OK
I can now program remote fobs correctly on my car.
Thanks Agent_Sm1th
