Center Bore K10 Help.

[Shaun]

I Know Everyone Is Sick Of Being Asked What PCD Do I Need?
Well I Know That It Is 4x100 And I Have Found Some Nice VW Wheels On Ebay That Im Gonna Bid On But... I Think The Center Bore May Be Smaller Than The K10's

Am I Right In Saying:
Micra 89 to 03 PCD = 4x100 Offset = 35 to 42 Bore = 59.1

And That As Far As I'm Aware All 4 Studded VW Wheels Are PCD 4x100
But According To This Site:

Golf I / Cabrio 76 to 98 PCD = 4x100 Offset = 35 to 42 Bore = 57.1
Golf II & III / Ventro 84 to 98 PCD = 4x100 Offset = 35 to 42 Bore = 57.1

The Bore Is Smaller... Is There Anything I Can Do To Fit These On Or Is It Just A No No...

Please Help Guys Bidding Ends In A Day!

Desperate Bump. :grinning:

 

[frank]

1mm of ally is quite easy to remove, but you have to be accurate tho

 

[Shaun]

would i be able to get a garage or somewhere to do that?

 

[frank]

would i be able to get a garage or somewhere to do that?

personally, i would sand the 1mm off with a 60mm flapwheel, but most people will say it has to be machined off on a lathe professionally (at the going rate of about £100 probably )

 

[Shaun]

ok i have no idea what a flapwheel is :grinning: but being it only 1mm difference surely it cant be that hard and £100 for a mm taken off

 

[boyracergt]

if you check out my blog in the first pictures ive got a set of mk 2 golf wheels on mine they went on fine but the offset was rubbish they sat a good inch outside of the wheel arch lol