Search results

  1. wehey

    I've tried to find the correct thread with no luck. So here goes: would 1.4 cams fit a 1.3?

    They will fit but there is no dizzy slot in the 1.4 cams as its from a coilpack engine
  2. wehey

    Why is my wheel wobbling?

    I would also say plastic wheel trim.
  3. wehey

    A few bits and pieces for sale

    No sorry, I'm keeping it as a spare
  4. wehey

    A few bits and pieces for sale

    Left and right driveshafts - £10 each
  5. wehey

    Replace Radiator on K11c

    You have to remove the upper cross member. Simple job At both ends are 2x bolts, These need removing along with the bonnet catch And maybe a few other bits (can't remember exactly) Watch out as the 2 x bolts are normally rusted so soak with some WD40 or similar over night
  6. wehey

    Pao - Critically ill, info sought!

    Me too. Just love the Pao but getting body parts puts me off a little
  7. wehey

    Immobilisation...???

    You could just pull out the fuel pump fuse. It's located in the fuse panel by your right knee. It takes seconds to locate and pull out
  8. wehey

    A few bits and pieces for sale

    I have some bits for sale from a 1997 1.3 K11. It will be heading for the scrapers once stripped and I will add items as and when I can release them from the cars rusty grip. Some bits will be too big to post so collection from BN15 Exhaust pipe middle section. In good con diction, too good to...
  9. wehey

    Weird happenings when cold

    Since fitting a 1.3 into my K11 I have noticed it runs a bit weird when cold. There seems to be a really bad flat spot at certain revs (don't have a Rev counter fitted) which is most noticeable at 40mph in 4th. I put my foot down and absolutely no acceleration. It's fine once I have a few miles...
  10. wehey

    what did you do to your micra today ?

    You could always just paint the centres black and leave the edges silver? Looks quite good on a silver car
  11. wehey

    My problem with modern cars

    I have had both on a Micra and massively prefer to have power steering than not. It's just so much easier and nicer to drive
  12. wehey

    Jelly like

    As above ^ The handling can be greatly improved for very few £'s
  13. wehey

    Fitting 1.3 head & cams to a 1.0

    It would be a facelift if it's 1998
  14. wehey

    Fitting 1.3 head & cams to a 1.0

    Do you know if it's a facelift model or pre-facelift? Prefacelift 1.0L boxes have a 160mm clutch/flywheel Preface 1.3, facelift 1.0 and facelift 1.3 have a 180mm clutch which is preferable starting point. It's a bit beyond my scope of knowledge regarding the clutch. Hopefully someone else on...
  15. wehey

    Fitting 1.3 head & cams to a 1.0

    What year is your Micra? The gearbox should be fine but the clutch can be a weak point as the hp rises
  16. wehey

    Fitting 1.3 head & cams to a 1.0

    You only need the engine and can keep your box. Try ebay searches especially "breaking" Micras Local scrap yard Wanted section on here For sale section on here Ask on the facebook page
  17. wehey

    Sump replacement

    I think you will find that you have to remove the centre member because the oil strainer sits really low in the sump and there isn't enough room to drop the sump down to clear it
  18. wehey

    Fitting 1.3 head & cams to a 1.0

    Plus I have just looked at the advert and £99 + £60 delivery is massively overpriced!!!! You can get a complete engine for less than £100 Just ask on here or on facebook for a set of cams. Expect to pay £30-£50 for a set :)
  19. wehey

    Fitting 1.3 head & cams to a 1.0

    You only need the cams as the head 1.3 head is identical to the 1.0 :)
Back
Top