Search results

  1. A

    Im going to go bald....!!!!!!

    Me and the trike, with my mate Iain whose helped loads.... Bazza :)
  2. A

    Im going to go bald....!!!!!!

    I got it MOT'd and taxed today....did about 100 miles. All seems well and good. I had to get it weighed to verify the class of MOT. Class 3 or 4. Its a 3 as it came in at exactly 400kgs with both petrol tanks full. F*** does it get off the line.....!!!!!!! (Y)
  3. A

    Im going to go bald....!!!!!!

    All done and dusted. Took the top of the carb of (AGAIN) and blew it out with a mates portable high pressure air compressor... Been about 20 miles in various conditions with no missfire or problems. Its running real nice and smooth (and NOT slow) (Y) Thanks for everyones replies on my posts...
  4. A

    Im going to go bald....!!!!!!

    Cheers (Y) If the points dizzy sorts it, l'd like an electronic one if you have one.....I'll post tomorrow when lve worked it out Bazza :)
  5. A

    Im going to go bald....!!!!!!

    Cheers Ed.....this is getting very frustrating. Ive just found the old 1.0 dizzy with points, under a pile of old bits in my garden :blush: . Ive cleaned it up, set it and will try it Sunday. If that solves the problem then l will find another electronic one. Same goes for the old carb, but...
  6. A

    Im going to go bald....!!!!!!

    Im suspecting the ic-igniter unit inside the dizzy, but just found out that l cant buy just that bit from Nissan !!!!!! Only a whole dizzy at £200+ :( Ive found a whole new electronic dizzy on evilbay much cheaper, (£50) but its listed as a 1.0 model....would that not be the same or okay to...
  7. A

    Im going to go bald....!!!!!!

    Its not the catalytic model......but it has got electronic ignition..are the coils different for points/electronic, and do they need/not need condensors or ballast resistors...? My brain is melting.........:p
  8. A

    Im going to go bald....!!!!!!

    Im tearing my hair out !!!!! :( My 1.2 (conversion) ran fine for 30 minutes while getting it warm and checking autobox levels etc.... Then it went up the road 200 yards and started spluttering again AAAAARRRRRGGHHHHHH. The choke is definitely on when cold and off when warm. The anti-d plunger...
  9. A

    I need advice to get my K10 running again (ENGINE CONVERSION)

    How can you tell if the motor/carb is an Eccs type......?? Bazza
  10. A

    black exhaust smoke help me please!!!!

    If its not 'connected' doesnt that mean its on permanently...? The wire makes it come off....no ??
  11. A

    It lives !!!!! (and another question :) )

    Not much room :( Its still got the little middle box squeezed in underneath and a motorcycle end can running up the back now......not noisey but a nice note.....:wasntme: Bazza
  12. A

    It lives !!!!! (and another question :) )

    Yep standard filter..but the exhuast is a bit shorter and free flowing. I'll try retarding the ignition a bit then. Thanks (Y)
  13. A

    It lives !!!!! (and another question :) )

    Hi all......with the carb, tanks, pipes cleaned, with new filters, anti-d plunger removed and the tickover solonoid left intact but disconnected..it started straight away !!!!! And seems to run fairly okay. There is a hint of pinking though.....l have not touched the ignition at all. When it...
  14. A

    Hello and a question

    Yep, hopefully new disks and pads is all it needed. The pistons were nice and free...but lve got a remote servo assis on another trike thats off the road, so l could use that if need be.
  15. A

    Hello and a question

    Ive just stripped, cleaned and re-assembled the carb. Ive taken the plunger out of the anti-D.....but lm going to put the tickover plunger in without connecting it to any wires. Hope this works. Should find out soon enough.. :)
  16. A

    Hello and a question

    I was talking with someone about that today and wondered how they got around the fact that someone might sit in the car with the ignition on without starting it.... ....any idea how the tickover solonoid should be wired ??? Or can l just take out both plungers and not worry ??? Im gonna...
  17. A

    Hello and a question

    Im running an AP Lockheed racing M/Cl which would run a pair of 6 pot bike calipers. No vaccuum assist.....(yet)
  18. A

    Hello and a question

    Thankyou very much for the offer, much appreciated, but l dug deep in my pockets and got these; Havnt had a chance to try them yet :(
  19. A

    Hello and a question

    Oh.. :o Now lm really confused :down: I have a connector with 2 wires coming from the alternator....they are both live. 1 goes to the auto choke and the other to what is now the anti-d......... The solonoid with 2 wires l had simply wired up to a 12v and an earth as l thought it was the...
  20. A

    Hello and a question

    Hi, can someone help me identify which solonoid is which, please... Am l right in thinking that one of these is the anti-dieseling and one is the tickover adjuster...? The book lm reading says the opposite of what l thought l had worked out.....:( Thanks..........Bazza (Y)
Back
Top