I've just changed the crankshaft sensor again... and had a good wiggle of all the wires I could see around the engine block... and its started and is running fine now (its not even bringing up the engine light). Wish me luck to see if it starts in the morning. Would the crankshaft sensor bring...
I'm not sure how to get to the tensioner. I now think it may be the wiring loom. I tried another sensor yesterday. Anyway it started but ran really rough... Like if you took a spark plug out. I had no power especially up hill. I swapped back the sensors... But it made no difference. An hour...
Reading another forum it says there are 2 camshaft position sensors. I can only find one there is a similar straight one on the gearbox... I beleive this is the crank angle sensor. the one I changed is higher up located on the right hand side of the engine towards the back and near the top...
Hi Andrew did you solve this issue? I only ask because I have the same codes on an 04 Micra. It only happens from a cold start and the idle is up and down for the first minute or so. After that the car runs fine. I tried a new cam sensor but the car wouldn't even start (just fired up quicker...
Hi everyone. I own a 2004 Micra (K12). I'm new to this so I apologise because I have seen this subject before but I don't know if it fully answered my question (it suggested I need a new timing chain).
I'm getting error codes 0340 and 0111. This indicates a problem with my cam sensor. This...